• 1). Take budwood cuttings for T-budding in mid-June when bark "slips" (separates easily from the inner wood of your fruit tree). Gather the bud cuttings from vigorously growing shoots of the current season's growth.
  
  
• 2). According to Geoff Bryant in his 2003 book, "Plant Propagation A to Z", you should look for a healthy leaf with a firm, plump bud at the leaf axil. Cut off the leaf leaving a stub that you can use to hold and manipulate the bud while grafting.
  
  
• 3). Using a sharp knife, slice into the wood at an angle ½ to ¾ inch below the chosen bud. Draw the knife up under the bud and cut until ½ to ¾ inch above the bud. Make a cut across the stem at this point and peel the bud from the stem.
  
  
• 4). Peel the bud back, taking only the cambium layer (the thin layer between the sapwood and bark) with it. Too much wood prevents implanted buds from taking quickly. Cut or peel away excess wood.
  
  
• 5). Place the budwood cuttings on damp paper towels and roll up gently if making several cuttings. Use budwood cuttings right away or very shortly after taking them.
  
  

Taking Softwood Cuttings

• 1). Take softwood cuttings in the late spring or early summer from new growth. Use healthy, vigorous plants for cuttings and avoid wilted or obviously insect infested fruit trees. Take cuttings just before you plan to use them.
  
  
• 2). Test to see if you have true softwood. According to Miranda Smith in her 2007 book, "The Plant Propagator's Bible", bending branches at a 90 degree angle 6 inches from the tip will tell you whether you have softwood. "Hardwood won't bend at all, and branches that are too young to cut won't break."
  
  
• 3). Cut a 4 to 6 inch section from stems that have stopped growing at the tips but haven't hardened completely yet. Make a 45 degree cut 1 inch below the spot where a leaf joins the stem.
  
  
• 4). Remove all but the top two leaves from the cuttings and roll the ends up in wet paper toweling. Put the cuttings in your container. Cuttings should be planted immediately after you have taken as many as you need.
  
  
• 5). Dip the tips of the cuttings in rooting hormone after removing from the wet paper toweling and before planting.
  
  

Taking Hardwood Cuttings

• 1). Take hardwood cuttings, called scions, in late fall when your fruit trees have gone dormant.
  
  
• 2). Choose one-year old wood that is vigorous and not diseased or insect infested. Use the thinner wood at the ends of the one-year-old growth. Scions should be as big around as a pencil, or at most ½ inch thick.
  
  
• 3). Cut scions 8 to 12 inches long by making a straight cut just below a growth node. Make a 45 degree angled cut above a node near the tip to remove soft wood.
  
  
• 4). Make small bundles of 6 to 8 cuttings by tying them together with garden twine. Wrap the cutting bundles with moist (not soaking) peat moss. Put your wrapped scion bundles into plastic bags.
  
  
• 5). Put the date cuttings were taken, the type of fruit tree, and the variety name on a label and attach it to the scion bag.
  
  
• 6). Put the scion bags into the refrigerator to cool and callus over winter. Keep them away from fruits and vegetables in the refrigerator.