Nicro Solar Vent Installation Instructions
- 1). Place the solar vent on top of the cabin in the location where you want to install it. Use the pencil to draw a circle around the vent. Use the saw to cut a hole using the line as a guide. Be sure to cut right on the line or just outside of it, not inside or the vent will not fit. Use the sandpaper to smooth the inside of the hole.
- 2). Place the trim ring into the hole from the interior. Mark the screw holes with the pencil and then use the power drill to make 5/32 inch holes. Replace the trim ring and use the screwdriver to insert three 10-by-3/4 inch screws which are provided.
- 3). Place the base plate into the hole from the exterior and mark the holes with a pencil. Use the drill and the same bit to make three holes. Place a line of sealant around the edge of the hole and on the bottom lip of the base plate. Press the base plate into place in the hole, lining up with the screw holes. Insert three provided 10-by-1 inch screws with the screwdriver.
- 4). Place the cover over the top of the base, aligning the screw holes on the cover with the openings on the base. When the cover is aligned, insert the cover screws into the holes and tighten them in place with the screwdriver.
Source...