How to Install Toyota Tacoma Seat Covers
- 1). Pull up the back of the front seat covers and remove the metal clips with hog ring pliers. Pull off the plastic cover on the side of the seats that controls seat movement.
- 2). Take off all of the headrests from the seats and set them aside to cover separately.
- 3). Slip the bottom section of the front seat covers onto the lower portions of the front seats. Pull the fabric down around the sides of the seat and push the back flaps and strings through the gap between the seat and the seat back.
- 4). Gather the strings on the back of the seats until the cover is tight against the seat and push the strings under the seat. If your covers don't have strings, attach the straps or whatever catches your covers have in the same way.
- 5). Pull the seat back cover for the front chairs over the seats. Push the front hook and eye adhesive flap through the gap between the upper and lower sections.
- 6). Adjust the seat covers so the holes in the top line up with the holes for the headrests. Run your hands firmly down the sides of the seats to move the cover into the correct position.
- 7). Push the fabric gently up from the outer lower corners toward the top of the seat. To set the covers in place, properly drag your hands down the front of the seat.
- 8). Pull the flap from the front of the cover all the way through the gap in the seats and press the coordinating hook and eye adhesive against it to secure the cover in place.
- 9). Lift the back seats up and slip the covers over them, passing the lifting straps through the provided holes. Pull the strings on the bottom of the covers tight to secure it in place.
- 10
Unbolt the seatbelts from the back seats and slip the seat back covers onto the seats. Pass the seatbelts through the holes in the fabric. - 11
Reattach the seatbelt and arrange the holes for the headrests. Pull the cover down around the seats. - 12
Fold the seat down and secure the hook and eye adhesive flaps to hold the cover onto the seat. - 13
Cover each of the headrests with the headrest covers. Push the ends of the covers together to connect the hooks together and close the end. - 14
Release the inside cover of the armrest with a screwdriver and take off the top cover form the structure. Cover the top portion of the armrest and replace the pieces in the original formation.
Source...