How to Open a GE Hotpoint Washer to Change the Pump
- 1). Unplug the GE Hotpoint washer power cord from the wall outlet. Shut off the water supply to the washer by turning the two water-supply spigot handles at the wall clockwise until they stop.
- 2). Place the blade of a two-inch putty knife in the seam between the front and top panel of the washer, four inches from the outside corner. Push the blade into the seam to slide the blade over the internal spring clip. Lift up on the same corner where the putty knife is to release the top panel corner from the top of the front panel. Repeat for the opposite side of the washer.
- 3). Grab the top of the front panel with both hands and pull it slightly toward you. Lift the front panel up and away from the GE Hotpoint washer. The pump is now visible and accessible below the washer tub.
Source...