How Do I Clean a 2000 Dodge Stratus SE Headlight Assembly?
- 1). Pop the hood and go directly behind the headlight. Locate the access point to the headlight assembly box. Use the appropriate screwdriver to remove the mounting screws holding the box in place.
- 2). Tip the housing forward slightly so you can grab hold of the connector cord. This cord runs power from the electrical system to the light box. Depress the tabs along the cord and disconnect it from the assembly.
- 3). Spray some canned air into the assembly to remove dust and dirt. Use a clean rag to brush out any remaining grime.
- 4). Rub some denatured alcohol onto a clean rag. Polish both the inside and the outside of the lens. This will remove any yellowing or cloudiness. Add a coat of car wax to the inside of the lens. Buff the wax off after a couple minutes for best results.
- 5). Plug the cord back into the light box. Push the box back into position. Secure with the mounting screws. Close the hood of your Dodge Stratus.
Source...