Moving Laser Beam

• 1). Remove the laser sight from the barrel and check the plastic caliber adapter installed at the stem.
  
  
• 2). Check to make sure that the adapter is for the caliber of the weapon that you are sighting in. For example, you cannot use the .22 caliber adapter to sight a .30 caliber rifle. If necessary, change the adapter to the appropriate caliber.
  
  
• 3). Place the bore sighter back into the rifle barrel, making sure that it is in as far as it will go and that you're not aiming the rifle downward. A downward angle can cause the bore sighter to slip out of position.
  
  

No Laser Beam

• 1). Remove the plastic turn switch on the side of the bore sighter; it is held in position with a small spring. This switch both turns the bore sighter on and off and holds the batteries in position.
  
  
• 2). Remove the batteries and replace with fresh ones, and make sure to install the batteries correctly.
  
  
• 3). Check the laser by turning it on; if the laser fails, it may be an internal problem which is beyond simple troubleshooting. If this is the case, contact LaserLyte for instructions.