Removing the Fuse

• 1). Turn the truck's engine off and open the hood.
  
  
• 2). Remove the cover from the fuse block in the upper-right hand corner of the engine compartment. Locate the fuse labeled "B/U LP."
  
  
• 3). Remove the "B/U LP" fuse with your thumb and index finger.
  
  
• 4). Place the cover back onto the fuse and close the hood. If you wish to enable the back-up lamps again, simply reinstall the fuse.
  
  

Removing the Bulbs

• 1). Turn the engine of your truck off and open the tail gate. Put on the gloves.
  
  
• 2). Remove the inboard screws on the rear of the truck that secure the tail light assembly with a Phillips screwdriver.
  
  
• 3). Pull the tail light assembly out of the vehicle.
  
  
• 4). Remove the middle socket. This is the back-up lamp socket. Rotate the bulb counterclockwise and pull it out. Place the socket back into the tail light assembly.
  
  
• 5). Place the assembly back into the vehicle and reinstall the two screws. Close the tail gate. When you wish to use your back-up lamps again, simply reinstall the bulbs.