Things You'll Need

Instructions

1

Determine how many concrete protective tents you need. Various manufacturers make concrete protective tents, and the measurements for each tent are different. Calculate how much space you’ll need to lay the brick wall and use the appropriate size and number of tents.
2

Set up the tents according to the manufacturer’s instructions. Because each tent is manufactured differently, the installation process will vary. When fully installed, the tent should extend past the location in which you plan to lay the brick wall. The roof of the tent should slope down and protect the future brick wall from all rain.
3

Assess the area during a rainstorm to ensure that no rain will penetrate the tent. The ends of the tent will allow some water to sneak through, but that water should have no effect on your wall. Your main concern is the front and back of the tent, where the wedged design should adequately prevent water from splashing against the brick and mortar.
4

Build a frame with 2-by-4 pieces of lumber. All brick walls require a structurally sound foundation. The frame must be set into the ground, at a depth that depends on the size of your wall. For a general rule of thumb, Douglas Whelpdale of The Guardian suggests digging about 1 1/2 feet into the ground for a wall that will stand 3 feet tall.
5

Fill the frame with either mortar or concrete. Allow the mixture to cure according to the manufacturer’s directions. Use a trowel to keep the mortar or concrete level as you pour it in place.
6

Mix the mortar for the brick wall. Although each manufacturer has different mixing requirements, you’ll need water and a wheelbarrow at the very least. Use a wooden mixing stick.
7

Scoop a good amount of mortar onto your trowel and spread it along the foundation, until you reach the end. Lay down the first brick and tap it in place with your trowel. Slap a small amount of mortar onto either end of the next brick and place it against the first brick. Wipe off the excess mortar with your trowel. Use a level to ensure the bricks are level as you go. If a brick isn’t level, gently tap it with your trowel.
8

Remove the concrete protective tent after the rain stops. Speeding up the curing process requires you to expose the mortar completely to air and sun.